Sauna lighting: which lights take the heat, and where they go
Light in a sauna has three jobs. It should show you the step and the edge of the bench, let you read the thermometer and get you back to the house after dark, all without a bright lamp in your eyes. Harvia keeps the lamps low in its own saunas, hidden from view. Plan where the lights go with your electrician and check what comes with the lighting you choose, including whether each fitting can cope with the heat.
- Low and indirect. Light under the benches, behind a backrest or through a shade on the wall, so nobody stares into a lamp.
- Rated for the room. IP65 describes protection against dust and water jets. It tells you nothing about heat. Ask for the fitting’s temperature limit.
- Planned with the cabin. Choose our lights in the build. They go in during cabin assembly, and your electrician wires them to BS 7671.
What should sauna lighting let you see?
The door, the step, the bench edge and the thermometer, from every seat and from the doorway. Harvia’s approach in its own projects is indirect light, so you can see your footing while the lamps stay out of sight.
When Harvia refitted the saunas at a Finnish golf club, its designers put the LEDs “under the benches and behind the backrests”, aiming for light bright enough to see where you step and soft enough to relax in. A garden sauna needs the same thing on a smaller scale. You come in from the dark, often with wet feet and a towel in one hand, and you sit facing a wall or a glass door for a long time.
Start with a sketch of the room. Mark the door, any step or change of level, the heater, the benches and where the pail and the thermometer will sit. Then look at the sketch from the bench: a lamp directly opposite your eyes, or one that reflects in the glass door, will bother you every session. Our guide to sauna benches shows how tiers and steps change the room, and both levels need checking.
Can any LED strip go in a sauna?
Only a fitting whose maker confirms it for the heat, the moisture and the position you have in mind. An IP rating covers dust and water. Check temperature suitability separately. Our lighting pages give IP65 for the bars, the exterior lamp and the kit, and no temperature figure.
A sauna room is hot, humid in bursts after each ladle, and hottest under the ceiling, so a light that suits a bathroom may not suit it. The IP code on a lamp describes protection against dust and water. Check the heat rating separately. The driver has its own limits, as do the cable and connectors. Ask for the fitting’s instructions before you buy it, and let your electrician decide whether it suits the place you want it.
Our product pages list each set’s contents and intended positions, with an IP65 rating. They do not give a maximum operating temperature or light output, or say whether the lamps dim. Ask us for those details before choosing. If you want a light somewhere other than its intended place, high on a wall instead of under a bench, ask before ordering.
Sauna lighting lets you see the room. It serves a different purpose from red-light or infrared therapy, neither of which we sell.
Where should the lights go in a sauna?
Low and out of the line of sight: under the benches and behind the backrests, with a wall lamp behind a shade. Keep every fitting out of the heater’s safety clearances, away from the hottest air under the ceiling, and clear of the fresh-air vent and outlet.
Under-bench light does most of the work. It lights the floor and the step, and the bench itself hides the source. A wall lamp behind a timber disc or a slatted shade gives a soft glow to read the thermometer by. Both stay below the hottest layer of air, which gathers under the ceiling, as our guide to sauna temperature explains.
The heater sets hard limits. Follow the clearances in its manual. The Harvia Cilindro PC70 we offer needs 100 mm around the heater and 950 mm above it. Keep that space clear, including any lamps. Keep the lights clear of the vents as well, so the airflow described in our garden sauna ventilation guide still works.
Glass changes the picture after dark. A glass door or a panoramic back wall reflects a lit room back at you once the garden is dark, so check the view from the bench towards the glass, as well as the light itself.
What comes with our sauna lighting?
Interior lighting gives two IP65 LED bars for under the benches and a round wall lamp behind a timber disc. An exterior IP65 lamp by the door runs from the interior set’s power supply. The LED kit combines two interior lamps and one exterior lamp. You add each option in the build.
| Option | What it contains | Note |
|---|---|---|
| Interior lighting | Two IP65 LED bars for under the benches, a round wall lamp behind a timber disc, power supply, switch, cables and connectors | Black or white switch and fittings |
| Exterior lamp | One IP65 lamp on the outside wall by the door | Runs from the interior set’s power supply, so it comes with the interior lighting; black or white |
| LED lighting kit | Two interior LED lamps and one exterior lamp, IP65, with driver, switch and seven connectors | Black or white |
| Wooden lamp shade AUP3 | A slatted wooden shade over the sauna light, 290 × 275 × 62 mm, 0.5 kg | Check the space around the light fitting |
Choose either the kit or the interior set by name, since they contain different parts. Keep its packing list with the cabin manual. You add it to the build on the sauna page for fitting during cabin assembly. We do not sell any of them on their own. For a replacement lamp in a sauna you already own, ask its maker.
The AUP3 shade softens a sauna light to an even glow. At 62 mm deep it needs a little room around the fitting, so mark its outline against the bench and the backrest before you order it.
Is one lamp by the door enough for the garden?
For the doorway, yes; for the walk back to the house, maybe not. Our exterior option is one IP65 lamp on the cabin wall by the door, and its page gives no coverage figure, so walk the route after dark and light the path separately where it needs it.
The walk to and from the house is part of every session. Try it at night in a robe and slippers, noting the gate, the turns in the path and any step up to the cabin. Our guide to the garden sauna room covers where you change and cool off, and those places belong on the lighting plan too.
Your electrician can fit path lights and garden sockets as part of the same job. They count as ordinary outdoor electrical work and fall outside our lighting options.
Do sauna lights need an electrician?
Yes. Our lighting needs a small circuit to the cabin. A qualified electrician must design it and provide protection to BS 7671. In England a new circuit is notifiable work under Part P, and a room containing a sauna heater is one of the special locations in the rules.
All three lighting options need fitting during assembly and a small lighting circuit to the cabin. For an electric build, include that run in the heater work. A qualified electrician sizes it and provides protection to BS 7671. That does not mean the lights can simply share the heater circuit. The electrician designs both together.
The IET’s guidance on Part P in England lists the installation of a new circuit as notifiable work, and names a room containing a sauna heater as a special location, where any addition to an existing circuit is notifiable too. An electrician registered with a competent person scheme can certify the work. Different rules apply in Wales, in Scotland and in Northern Ireland. Our guide to outdoor sauna electrical requirements covers each nation alongside the heater supply.
A wood-fired cabin needs no heater circuit, but it still needs that lighting circuit if you choose our lights. You, or someone you hire, build the cabin from the manual, so plan the electrician’s visit around the assembly: agree the cable route and switch position before the panelling closes over them.
How do you check the lighting before you use the sauna?
After the electrician has finished and tested the work, lay the room out as you will use it, with towels and the pail in place, and look from the door and from every seat: the step, the bench edge, the thermometer, then the way back outside.
Towels and a pail can shade a bar under the bench, so check after putting them in place. Sit on each bench and look towards the door and the glass. If a lamp glares or reflects, talk to the electrician about its position before changing anything yourself. Keep the lighting instructions with the cabin manual and the electrical certificate. Our first-session guide covers the rest of the evening.
Quick answers about sauna lights
Our lighting pages do not say the lamps dim, so we cannot promise it. If you need a dimmer, ask before ordering and let your electrician confirm what suits the driver.
Your electrician sets that for the position, under BS 7671. Our bars carry an IP65 rating, as do the exterior lamp and kit. That covers dust and water jets. Ask the maker separately about heat suitability.
Leave it outside. Apple gives 0–35 °C as the ambient operating range for iPhone and iPad, far below a sauna. Use fixed lighting to see by.
Sauna lighting helps you see in a traditional sauna. Red-light and infrared therapy serve different purposes, and we do not sell those products.
Any new circuit or change in a room with a sauna heater is electrical work for a qualified electrician, and in England it is notifiable. Choosing our lights in the build lets them go in during assembly.
Six points for the lighting plan
Your ticks stay on this device.
Lighting chosen with the cabin
Each page offers interior lighting, the exterior lamp, the LED kit and the AUP3 shade in the build.

- Seats
- 3, L-shaped bench
- Outside
- 185 × 220 cm
- Hot room
- 206 × 155 cm
- Bench
- one height

- Seats
- 4, two a side, plus two porch seats
- Outside
- 240 × 220 cm
- Hot room
- 175 cm long, 206 cm across
- Benches
- 174 × 50 cm

- Seats
- 6 on two tiers, plus a side bench
- Rooms
- hot room, changing room and porch
- Outside
- 340 × 220 cm
- Hot room
- 206 × 185 cm
Sizes from the product pages, 11 November 2026. Each page lists the base, delivery and what is in the crate.
See our outdoor saunas
Choose the cabin and add its lighting in the build, then give the plan and the instructions to your electrician. An expert can answer your questions before you order.
What we checked for this guide
Lighting contents and ratings come from our product pages, November 2026; placement from Harvia’s Pickala sauna project; notification rules from the IET’s Part P guidance. Our pages publish an IP65 rating and no temperature rating, so we quote none. Checked 11 November 2026.
Related guides
Written by the Waldenhaus team. We sell outdoor saunas and greenhouses and write these guides from manufacturer manuals, official guidance and our own product pages. Where your equipment manual says something different, follow the manual.


